1 Pallet 36-5 Gallon Pails Solvent Bonding Adhesive B013NO4LJK

$9,875.50

In stock

SKU: IX-BREI-3CY8 Category:

Description

Description

Bonding Adhesive, is a solvent-based contact adhesive designed specifically for bonding EPDM Rubber or TPO membranes and flashings to wood, metal, masonry, and other acceptable substrates.

Method of Application

  1. Surfaces to receive EPDM Bonding Adhesive shall be clean, smooth, dry, free of sharp edges, loose and foreign materials, oil, grease, and other contaminants. Sweep the mating surface of the membrane with a stiff broom to remove excess dusting agent, if present, or other contaminants from the mating surface.
  2. Stir the adhesive thoroughly before and during use, achieving a uniform mix with no sediment on the bottom and no marbling evident. Stir the adhesive thoroughly before and during use, achieving a uniform mix with no sediment on the bottom and no marbling evident.
  3. Apply adhesive at about the same time to both the exposed underside of the sheet and the substrate to allow approximately the same flash-off time.
  4. EPDM Bonding Adhesive may be applied with a solvent-resistant paint roller or mechanical equipment designed to apply flammable solvent-based adhesives.
  5. Apply by rolling the adhesive on both mating surfaces. EPDM Bonding Adhesive should be applied evenly to avoid globs or puddles.
  6. As an option, spray EPDM Bonding Adhesive and back-roll the adhesive uniformly and evenly with a solvent-resistant paint roller. Care must be taken not to apply EPDM Bonding Adhesive over any area that will later be cleaned and spliced to another sheet or flashing.
  7. Allow EPDM Bonding Adhesive to flash off until tacky. Touch the EPDM Bonding Adhesive surface with a clean, dry finger to be certain that the adhesive is dry and does not stick or string. While pushing straight down to check for stringing, also push forward on the adhesive at an angle to ensure that the adhesive is ready (flashed off) throughout its thickness. If either motion exposes wet or stringy adhesive when the finger is lifted, then it is not ready for mating. Flash-off time will vary depending on the air conditions.